• From the OVA Mobile Suit Gundam Wing: Endless Waltz comes the newest Perfect Grade kit: the Wing Zero Custom!
  
• With a wingspan of over 27 inches and a height of 11 inches, this kit’s impressive silhouette eclipses many other Suits both in height and width! 
  
• Die-cast joint parts give the Suit a sturdy construction and low center of gravity and enable the builder to tighten them easily if needed.
  
• Rear center wings can be expanded with a spring mechanism for cleaning, and the large side wing’s feathers extend to give an impressive wingspan.
  
• Shoulder-mounted Vulcan Cannon hatches can be opened, and the cockpit hatch slides forward to open and reveal pilot Heero Yuy
  
• Center chest and “eye” cameras light up using included LEDs (batteries required)
  
• Rifle accurately moulded, fingers individually jointed and camera eyes moulded in transparent colored elements. 
  
• 
  
• Accessories: Accessories: Twin Buster Rifle, Beam Saber x2
  

• It is the brand new frame compatible for the non-transforming 4 out of the 5 Gundams 
  
• Derived from Wing Gundam Zero (Wing Gundam, Gundam Deathscythe, Gundam Heavyarms, Gundam Sandlock, & Shenron Gundam). 
  
• The snap mechanism of the wrist has been employed, to increase the poseability with weapons in hand, the forward and backwards movement range has been obtained. 
  
• Buster Shield: The beam effect part can be attached for the Claw Expanded mode. - Beam Scythe: The beam parts has been made with clear material, and can be detached. and equipped to the backpack. 
  
• Katoki Hajime has designed the markings. 
  
• Accessories: Beam Scythe, Buster Shield, Beam Parts for the Buster Shield Weight: 543g
  

• The stylish form rebuilt by Katoki had been reproduced. 
  
• Equipped with the wing area adjustment gimmick, with wide posing range. 
  
• Able to transform into the Bird mode. With the wings at center, the front/back balance had been pursued for a greater flight mode. 
  
• The action gimmick for the weapons has been reproduced too. The barrel can be taken down, and the saber will pop out. 
  
• Equipped with a locking mechanism during transformation. The rifle can be locked to increase stability. By cranking the side armor, the base of the arm shaft is locked, also locking the mobility of the waist during MS mode. This stabilizes the Bird mode. 
• - Leg transformation mechanism equipped. Linked with the knee joint, the ankle will move to it's storage position. (The ankle will be stored in the shin, reducing the total length) 
• - The cockpit has been reproduced, with the figurine included. The figurine of Heero has been reproduced at 1/100 scale with immense detail. The cockpit hatch can be liberated to open, to reveal Heero in his shirt. - Weapon/Accessories: Shield, Beam Saber, Buster Rifle, Heero Figurine Weight :591g
  

• Following EW ver. Death Scythe rated No.01 for item of most interest at the Tokyo Hobby Show MG booth, the Death Scythe Hell takes off! 
  
• Uses the XXX-G Frame developed during the animation!
  
• Marking work is designed by Hajime Katoki.
  
• Increased freedom of movement when set on Action Base, by the placement of joint at the wing connection part.
  
• New gimmick and mechanism equipped to the Active Cloak. By pulling from the base part of the wing, the internal machinery will appear. 
  
• Able to reproduce the flapping from the animation naturally. 
  
• The closed state of the Active Cloak can also be reproduced with a natural form. 
  
• Accessories: Beam Scissors, Active Cloak Technology & Combat Characteristics The Gundam Deathscythe was the "masterpiece" of Professor G. 
  

• The XXXG-00W0 Wing Gundam Zero (aka Wing Zero) is a mobile suit that appears in Mobile Suit Gundam Wing and its sequel OVA/movie Endless Waltz. Though having many pilots during its lifetime, the unit was most famously piloted by the series main protagonist Heero Yuy. 
• Wing Gundam Zero was designed by the five engineers fifteen years prior to the events of the Eve Wars, the Wing Zero is the ancestor of the five Operation Meteor Gundams (Wing, Deathscythe, Heavyarms, Sandrock, and Shenlong). Designed with "Perfect Victory" in mind, it boasts exceptional abilities and is one of the two suits which utilize the ZERO System (the other being the Gundam Epyon), but because of this dangerous mental interface, it was kept hidden away until Quatre Raberba Winner desperately built it following his father's death. Like the Wing Gundam, it can transform into a high-speed flight mode dubbed "Neo-Bird Mode." Further, its twin buster rifle has more than twice the output of the Wing Gundam's buster rifle, giving it enough power to destroy an entire space colony or resource satellite in a single shot. It features hidden thrusters in the shoulder armor, where the armor splits open to reveal the nozzles. The feet also house powerful thrusters in order to give the Neo-Bird Mode extreme speed.

HG 1/144 Wing Gundam Zero Custom

• SD Ex-Standard XXXG-00W0 Wing Gundam Zero EW
  
• SD Gundam EX-Standard (SDEX) is a line of super-deformed Gunpla kits of the Mobile Suits from the Gundam metaseries. To be introduced in late-2015, this is the latest in the long line of super-deformed kits. Each Gunpla has a gimmick wherein their weapons and accessories can be used with their respective High Grade Universal Century counterparts.
  
• The parts swaps and cross-compatibility introduced in SDBF carry over to EX-STANDARD, allowing for a wide range of customization options.
  

Mobile Suit Gundam Wing Endless Waltz: Glory of the Losers continues its amazing releases with the Master Grade Tallgeese Flugel! This kit offers numerous amount of newly molded parts, from its head to its wing binders. The kit also shares the same molds with the MG 1/100 Tallgeese EW for its main body and added with various equipment new to the Tallgeese Flugel, that includes both heat lance and heat halberd.

JMS HG 1/144 The Nascent Desert Sandrock Gundam

HG 1/144 HG 1/144 Wing Gundam

MG 1/100 Nataku/ Altron Gundam from Super Nova (Blue Version)

Kindly note that this kit is a NON-BANDAI product.

Second batch is open for Pre-order.

SD Ex-Standard Gundam Deathscythe Hell Ew

[11] XXXG-01S2 Altron Gundam (FG)

P-Bandai: MG 1/100 Wing Gundam Zero Custom EW + Drei Zwerg [Special Coating] 

[Super Nova - MoXin] XXXG-OOWO  MG 1/100 Wing Gundam EW Ver.

The Shenlong Gundam with its powerful extending unfolding right hand that features a dragon themed head with flame throwers. 

[Super Nova] 1/100 MG XXXG--01H2 Heavyarms Custom Gundam

Kindly note that this kit is a NON-BANDAI product.

• Name: P-Bandai : RG 1/144 Tallgeese II
  
• The kit provides a 1/144 scale figure of Treize Khushrenada, and a new set of realistic decal seal for detailing.
  
• One of the most anticipated Real Grade Tallgeese's variant is finally getting a GunPla treatment! Comes with newly molded head and face-plate design, along with recolored armor parts for Tallgeese II.
  
• Release date ETA December 2018 and delivery date around January 2019

• [M.J.H] 1/100 High Resolution Wing Zero Custom Gundam
  
• Brand: MJH 
• Grade: HIRM 1/100
  
• Box Size (L x W x H): 42.4cm x 28.4cm x 9cm
  

- From the TV anime [New Mobile Suit Gundam Gundam W], general unit of the MS unit Maguanac team composed of 40 units is three-dimensionalized with HGAC!

- Based on the concept of [Fine Build], adopt a structure pursuing ease of assembly.
- Shield for backpack, Heat Tomahawk for mount at the waist.
- Shoulder armor 's flip up gimmick.

[accessories]
Beam rifle x 1
- Heat Tomahawk x 1
- Shield x 1

[Product content]
- Molded parts x 6
- Foil seal x 1
- Marking stick x 1
- Instruction manual x 1